About this item
- The Fitment of Motor: The heater blower motor fit for Buick LaCrosse 2005-2009,fit for Chevrolet Impala 2004-2013, fit for Chevrolet Monte Carlo 2004-2007,fit for Buick Allure 2005-2009,fit for Pontiac Grand Prix 2004-2008.
- Replacement AC Blower Motor With Fan: is responsible for producing air that goes through the vents of your vehicle's AC and heating system. If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor.
- Feature of The Motor: Permanently lubricated self-aligning bearings with long design life and reliable performance. This high quality blower motor is a new aftermarket replacement part built on the most stringent quality control standards.
- High Quality: Top quality materials which provide maximum strength and durability,Material of rotor punching plate is silicon steel sheet. Enameled wire is used copper enameled wire.
- Every Blower Motor must take inspected and tested multiple times before the shipment.
*The AC Blower Motor is responsible for producing air that goes through the vents of your vehicle's AC and heating system.
*If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor.
*Step up from the ordinary, It is time to replace the blower motor that has stopped running.
*When you replace the blower motor, it is recommended to replace the new blower motor resistor.
*Please use the year/make/model drop down bar confirm the compatibility before purchasing.CC
Weak airflow for both the heating and cooled air coming out of the vent
No air pushing through the vents (motor broken down or bad control module)
Unusual blower noise such as a rattle or squeak (worn motor or bad bearings)
If you have an overheating blower motor, would be a burning smell coming from your air vents
Material of rotor punching plate is silicon steel sheet,avoid burning of motor
1.Remove the screws under the passenger side dashboard of the vehicle.
3.Disconnect the blower motor electrical connector.
5.Compare the new blower motor to the old one to verify that you have the correct part.
6.Install the new blower motor into the box and tighten the screws.
8.After the installation is complete, turn on the air conditioner and check if it is running normally.