NOTE: 1,Mounting brackets can be mounted horizontally or vertically depending on what fixture there is to install shades onto.

After determining location to install mounting brackets, use bracket as template to mark hole positions for pre-drilling holes in surface for insertion of plastic anchors.

NOTE:2 ,If medium onto which

brackets will be mounted to is

solid wood, plastic anchors are

not necessary. Directly install

with just screws if desireed.

For other medium such as

concrete or stone, anchor is required.

After holes are drilled, insert plastic anchors into hole until

flush with surface. If needed, lightly tap anchor into hole with hammer. Then attach brackets to surface with screws.

NOTE:3,Mountinq Vertically

Remove the four screws from both b『ackets. Turn the Clutch Unit 90 degrees so the clutch eyelet hangs straight down if the Clutch were hang-ing from the top, and turn the Idle End Unit so the opening is facing away from the window. Put screws back in.

NOTE:4,Last step is to install bracket holders for the bungee cord and ring that is tied to the ends of the shade. This is used to help tie down the shade during windy conditions. Install the bracket at a side location like with the mounting brackets. Make sure each bracket is at least 6 feet from the top of the shade and can be reached by bungee cord. Insert ring into the bracket to secure

NOTE:5,Remove the four sc『ews.

Turn the clutch unit 180 degrees so the wand eyelet can now hang down from the left side. Put the screws back in, and tighten. No change is needed to the Idle End Unit, it works for right and left mounts. Pull out both End Plugs from the tube and switch them.