It’s time to install air purifier to disinfect your home, office, care, halls and rooms. This fogger machine with the help of surface sanitizer spray eliminate all odors and germs from everywhere and make everything sanitized and disinfected


Product Features:


1. All the copper nozzle, joint use metal atomization nozzle, sturdy and durable for a long time

2. Dry, life is long, use the power of 900 w, heater voltage stability control system is strong, thick oil pump smoke, sterilization effect is good,


Recommended Use: This easy to carry and simple to operate Fog Atomization Machine is Highly recommended for sanitizing and proves to be air purifier for home large rooms kitchen, bathrooms, cars, hotel, hospitals, gyms, hotel and shopping malls. 

Operating Instruction:

1: Put the atomizing sterilizer in the car or any small space.
2: After turning on the power, Press the rear switch button to the right (I) position to warm up 5min.
3: Make sure at this time, the top red light is on.
4: Put the oil pump probe into the disinfectant.
5: Press the rear switch button to the left (II) position and turn On the silver timer knob to the right to start the machine to desired time of operation.
6: Now you can put the probe in the clean water to clean the machine.
7: When the cleaning is complete, you can mode the rear button to O and unplug the power.


Machine will Auto Stop and Auto Start during the operating for two reasons: 1st to allow the disinfectant to settle before the 2nd spray for the best result and 2nd it has over heat protection functionality.

Note: Sanitizing, Fog Liquid, Glycerin or an empty bottle is not included
Spraying antibacterial disinfection machine steps:

Step 1: Start the car, the car is inside the cycle, the wind speed is 3 files, and the cold air is opened. Power on the machine into the front passenger seat row and open the red switch button on the back of the machine.

Step 2: Wait for 5 minutes for preheating, wait until the handle light is on. Then press the timer switch (4 ml to 100 ml of option. Please set 4 or more below 80 ml.)

Step 3: Atomization for about 3 to 5 minutes, the liquid medicine is sprayed off the machine, take out the machine, continue the inner circulation for about 15 minutes, let it fully absorb.

Step 4: Ventilate, cycle outside for 3 minutes, the entire construction is completed, check the switch off and deliver.

Tips:
After the machine is finished, it is best to use a clear water spray. Keep the machine piping clean and unobstructed to prevent blockages from  affecting machine operation.

Cleaning Function:
Connect the machine to the power supply, press the black switch to the left cleaning position, turn the timing knob to about 2 steps, and rinse the machine pipe with clean water or clean tap water.